Air Lift Bioreactors
Modelo: FerMac
The Air Lift bioreactor can be used with our FerMac 360 controller, of where simpler control is required, the appropriate 200 series control modules.
This normally includes the regulation of pH, dO and temperature, but other control functionality (such as light) can also be regulated. As there is no motor unit involved, the bioreactor can also easily be integrated with other manufacturers? controllers.
Specially designed
Unlike traditional bubble columns, which are effectively just a tube with a gas inlet at the bottom, the Electrolab Air Lift incorporates a vertical division within the bioreactor tube. Carefully designed geometry and a specially designed off-set sparger enables the cells and media to be gently and efficiently circulated around the bioreactor.
Air (or other gases) is introduced at the base of the bioreactor. The stream of bubbles then causes the density of the media on one side of the division to decrease. Oxygen is dissolved into the media, sustaining the cells.
The gas flow causes the media to rise to the point where some of the bubbles burst into the headspace; the media then circulates down the other side of the division to the base, where the process repeats itself on a continual basis.
Marca: Electrolab Biotech
+54 9 11 6713-8305
